Levinson 332 v Levinson 431


I've had numerous problems with my Levinson 332 - it's been in for repairs numerous times over the past 3 year to replace capacitors and other components. The dealer is recommending that I upgrade to the ML 431.

Is this good money after bad or is this a genuine improvement?

The other components include the ML 39 and the ML 380S.

Appreciate any advice.
trader52489dc
I have both the Proceed AMP 5 and Proceed AVP. I bought them in 1998. Both units did not fully break in until about 1,000 hours of play (no typo).

Both the AMP 5 and the AVP have been the most reliable units I have ever owned, and the sound is excellent with my Musical Fidelity NuVista 3D CD Player and Martin Logan Ascents.

I will keep both units until they completely fall apart and cannot be repaired.

I would not worry too much about Proceed reliability.

If you have the chance to buy from a private party, I would go that route. Demo gear is left on all day, day in and day out, which I don't think is a good idea.

Also, remember to give both units air space in your equipment rack. The AMP 5 and AVP only become moderately warm in my experience after four hours of continuous use, and the AVP is much cooler than the AMP5.

I hope this helps.
Thanks for the advice. the units I have been offered are ex-dem, but apparently with little use. I've had them at home and the sound is really sweet. They botyh appear to run warm when left on standby, however, which seems a bit at odds with your experience

I don't leave my equipment in Standby mode. I turn off all of my equipment when not in use.

Just last night I watched three hours of Star Trek: The Next Generation (TV series), and my Amp 5 heat sinks were only warm to the touch.

I also have about 10 inches of clearance over my AMP 5 on my equipment rack.

My speakers are the Martin Logan Ascent i.

Maybe your speakers are drawing more current?

Also make sure not to block the air flow of either unit, and don't place the amp on the rug.
Thanks for this advice. I am sure this will help.I am using very efficient 94db speakers, so I doubt current draw is a problem. Still sounds great with my Wadia 6 Cd player. Don't think I can accomodate 10" clearance over the AMP, but probably 6" will be good enough. Anyway, what's a little heat. Just makes the whole experience warm!
Peter
Some heat should not be too big a problem for the Proceed gear. But excessive heat can add to circuit deterioration over time, albeit a long time. A six-inch clearance should be enough.

It's not so much the efficiency of a given loudspeaker, but its overall impedance curve that matters, as well as if there is any exaggerated phase angle along the frequency spectrum that might cause the speaker's impedance curve to dip to 2 ohms or below.

You may know that as a speaker's impedance decreases, especially in the bass and midrange region, current flow from the amplifier increases, and higher current flow, or draw, places a higher demand on the amplifier causing it to run hotter.

Best of luck!