How to track down bad tube and what can it mean?


I recently changed the tubes in my preamp and all but the driver tubes on my amp, but these tubes didn't work out. I replaced these with the stock tubes which had been good before. Now I get distortion from the left channel which sounds like a buzzing that comes and goes with the music. It increases with the volume. I've checked all the tubes and they are placed OK. At one point with the volume loud but not too loud the system turned itself off which had never happened before. My speakers are efficient and it was not putting out more than 10 wats max when this happend.

So how can I track down a bad tube if I have one? I suppose I could replace the tubes one by one with the new ones I tried, but this is extremely tedious and makes me dream of SS. Any idea what this problem, this sound indicates?

Any help is appreciated. My sick system depresses me. Thanks.
budrew
With my ARC PH-3, I had a situation were I replaced all the tubes with NOS JAN Philips and everything seemed ok for a while. Then, problems with the right channel. My intention was to put back the original Sovteks one by one until the unit worked, but after substituting just one the situation seemed ok. Short while later, problems with the right channel again. So I brought the unit in to the local ARC dealer for an inspection. Turns out the mute switch was bad. They checked the two sets of tubes I had and they elected to put back the original Sovteks, declaring them way better than the just recently bought NOS. Moral of the story: NOS may not be the best road to go down (conversely, ARC dealers may be averse to using anything other than what ARC sells???) and more than one problem can surface at once making diagnosis/repair best left to qualified techs. Good luck.
I'm facinated with the fact that the hum level varies with the level of the music - the reason is that the tubes in the line stage and amp are constant and merely pass on, amplified, what passes thru them. Question - does this problem occur with any source you select, or just one?
Thanks folks. I'll have to spend some time this weekend on this detective effort. The sound, a buzz that reminds me of a blown speaker though I did nothing to effect the speakers this way, appears with whatever source I have selected. This morning I switched interconnects between preamp and amp and the sound was still coming from the left channel. I'll try switching the left and right tubes in the amp and see where that goes.

Do you use a Q-tip to clean the tube pins?

If necessary I'll take the amp in for service, but it weighs 100 lbs so it's a freakin pain in the arse.
What did you buy for new tubes, and from whom? Are you still using the new tubes in your preamp, amp, or both? What make is your preamp and amp (monoblocks?)
I put the stock tubes back in both components and that's when the problem started. The new tubes I tried then removed were Electro-Harmonix purchased from Tubeworld. The amp is the Mcintosh MC2102 and preamp is C2200.