2. amps-preamps
  3. 1086582227

Any experience with unbalanced channels--7B-ST?

One panel of my SoundLab A3s is at the factory for diaphragm repair, so I've put my Maggie 3.5Rs back in service in the interim.

Last night I noticed that the three players of the Florestan Trio appeared to have moved stage left, a situation I hadn't really noticed before. (Much of my recent listening has involved less formally structured music, such as several bluegrass groups, including primarily AKUS, in which right/left balances are less noticeable.)

I then dug out Stereophile's test record and my Radio Shack Sound Level Meter to see if I could find the cause of this apparent unbalance. Sure enough, the left channel read 70dB, while the right ("stage left") read a solid 76dB on the track with white noise. After swapping inputs (XLRs from my Burmester 001) to the Brystons, I got the same result. Same after swapping speaker positions. So the problem appears to be in the amps. As a Hail Mary, I then switched the amps from series to parallel operation and the problem disappeared!

Perusing the final inspection test specs that came with the amps, I noticed that the left channel (Ser. No. 774380) clipped at 631 watts, right (Ser. No. 774379) at 689 in series operation. In parallel, left clipped at 608 watts, right at 589. Am I correct in attributing the channel unbalance to the greater disparity--left vs. right-- in series operation test results, or is there another problem that should be corrected? Can internal adjustments be made to balance the amps for series operation? Of course I'd expect to get balanced channels regardless of series/parallel settings.

I plan to contact Bryston, but in the meantime I thought I would consult the many knowledgeable members of this website
to determine if this situation has been observed before.
Jim
914nut
914nut OP
100 posts
 
Thanks for all the suggestions so far. Audiogon is a wonderful resource, thanks especially to respondents such as you.

I must say, however, that the suggestion that the Maggies may be at fault doesn't hold water. Please note that I've gone through all possible left/right combinations of inputs, speaker swaps, etc. with the same 6dB drop in the left channel in series operation (same amp in all cases).

The analysis regarding the effects of module bridging makes a lot of sense, and I wouldn't be surprised by the same response from Bryston when/if they answer my query of this morning.

Jim
ozfly
887 posts
 
Right you are Jim. I suspect Jameswei has it nailed. I definately answered too hastily on this one.
914nut OP
100 posts
 
Update:

I've heard from Chris Russell at Bryston who also feels that a module in the left channel amp has gone south. He suggested I check the two fuses adjacent to the IEC power connector. I did so and they checked OK.

Beyond that, he gave me the phone number/email address of the Bryston Service Center in VT. I called them and spoke with "Dennis", who gave me the shipping address for the return of the amp.

It will be in the capable hands of Fedex tomorrow. If what I've heard/read about Bryston, I might have it back next week. That would be nice!

Thanks again for all the suggestions and kind words of encouragement.

Jim
914nut OP
100 posts
 
Update:

According to "Dennis" at the Bryston Service Office in VT,
my amp has been repaired and is being shipped back to me. (I have confirmed the fact that the amp indeed went to UPS today and I have a tracking number.)

Culprit: the "Series/Parallel" switch was defective.

If the "guaranteed" delivery comes to pass (Friday, 18 June), that's not too shabby a turnaround: 11 days, including 8 days transit (ground)* up and back, Fedex/UPS respectively, and involving a weekend of no activity.
* Interestingly, the shipping rate for guaranteed 3-day service is over twice the ground rate, which is also guaranteed 3-day service in this particular set of circumstances. I KNOW I'm in the boonies, and can only speculate from perusing the map that the Bryston facility is similarly geographically challenged; this may explain the disparity. (Remember Clooney's line from "O Brother....": "You're two weeks from everywhere!")

My only complaint is that I had to call them to get a status report, which seems to be SOP these days.
As a retiree I easily forget the fact that they (Bryston) probably have other kettles of fish to tend in addition to those I inflict upon them, however.

Hopefully I'll be able to put my 27 year old Optonica SA5151 receiver back into the closet. I've gotta say, however, it's capable of pretty decent sound, when paired with my Burmester 001 (feeding directly into the main amp section of the receiver) and Maggie 3.5Rs.
Jim
More to discover