Output Impadence for Musical Design SP-2B


I want to know if anyone can tell me the output impadence for the Musical Design SP-2B linestage. I recently purchased this tube preamp used and would like to know the output impadence so that I can have an idea as to which power amps it can work with. I have e-mailed Musical Design but they haven't gotten back to me so I figured I'll throw this question up in the air for someone to help me out with. Thanks
speedracerucr
If that is indeed the case (2-2.5K Ohms for the SP-2B), what input impedance should I look for in an amplifier inorder to avoid the problems associated wtih impedance mismatch? In addition, is it a good or bad idea to mix tube pre with SS power? Thanks.
The input impedance of the amplifier should be equal to or higher than the output impedance of the preamp. Since paractically it is impossible to match the input and output impedance exactly, all you have to do is to be mindful that the amplifier's input impedance is higher than the output impedance of the preamp. This will be true for both SS and tube amplifiers fed by a tube preamp. So, it really will not be a mismatch to use a SS amp which has a higher imput impedance than the SP-2B.
Brokenarrow,
You are right on with your description of the SP-2B. Jonh Hillig of Musical Design wrote back with pretty much the same info. Here is his e-mail reply in case anyone else needs the same info:

"The figure is around 2K Ohms. We have used this preamp in a wide range of set-ups including driving two of our own amps at some audio shows. That's a 12k load. It works extremely well with a wide variety of power amps."

Now, that is good and all, but I don't understand how the SP-2B with 2K Ohms output impedance can drive amps with input impedance of 12K ohms. That deosn't fit into the 1:10 minimum ratio that I have been reading about in other posts regarding impedance matching. If anyone else can enlighten me on the matter, it would be much appreciated.