Rotel RMB vs. Sunfire Cinema Grand


Hi guys,
After months of searching and reading etc, I have narrowed my selection of amplifiers down to two.
I am very much interested in what a Sunfire Cinema Grand could do in my system. My Infinity Kappa 600s (Front) and 400s(surrounds) are wheezing with the 50-watt Adcoms I have pushing them, and they are bi-wireable, thus the Sunfire, with it's voltage and current source posts for the fronts seems like the logical choice. THey are available here on the 'Gon for around $1,500 used, or less, and $1,699 B-Stock from various dealers such as ATS.
THe Rotel RMB-1075 is not as powerful, nor does it have the flexibility of biwiring, but it would save me roughly $600, and I could buy the Rotel here in town at my dealer, new in box with factory warranty. It would also leave me room to upgrade my interconnects as well.
Can anyone attest to the benefits of said biwiring, and are they worth it as far as musical performance goes? I am a fan of high-rez digital sources, SACD and DVD-A, and of course need the best performance possible in two-channel mode. (The best performance short of Halcro, Theta, VTL, etc!)

Any suggestions would be helpful. I am quite treble sensitive, and many amplifiers sound a bit edgy or bright - maybe a good amplifier will correct the harshness my Kappa's produce at limits of their amps - when auditioned with B&K amplification, they sounded wonderful and wieghty, but were very fatiguing, thus I am not looking at B&K!

Thanks! Happy Listening!

Jon BRown

breitlingdj@yahoo.com
breitlingdj
I was recently considering upgrading my HT amp, and took the Rotel 1095 home for an audition as well. I have to agree with your accessment, I found it brighter then my current amp (H/K sig 2.0), and despite the much better power ratings (200 watts vs. 100), it wasn't much more powerful. I did notice more detail, which was both good and bad, but overall it certainly was not worth upgrading too. I'd describe the H/K's sound as warm and laid back which is perfect for movies, which tend to be bright. My only real complaint was that it was dull in 2ch. Sometimes you see them here for around $500, but they are getting rare. I have yet to find a musical 5ch amp < $1000 that does well for music. I ended up getting a sim audio integrated for my cds which has HT bypass, and have been happy since.
WEll,
My cable selection has always tended to the warmer/darker side of things, as has my selection of the particular Infinities I purchased. I am using speaker cables from MIT and Transparent, with great results, and if the Rotel happens to be a bit bright, a few Interconnects could change things a little.
My local Rotel dealer has a floor model of the 1075 that I am going to get a great deal on, so I think that I will go in that direction. If I end up hating the way it sounds, I'll take it back, but considering my strange amalgamation of amplification (say that three times fast!) I think I ll be OK.
H/K AVR 430 - center and multiroom
Mitsubishi DA series amplifier (75w per x2) fronts (which is now dead!!!) replaced by Adcom 5002 for fronts, and when i had to move the Adcom, I had to drag my old 8ohm rated Infinity Entra floorstanders as rears and amp them from the reciever.
I hope my dealer will allow me sufficient audition time. THe amp is a floor model, so break-in time will be negligible. I'm feeding it with a Transparent PowerLink Plus for power, and most likely MIT Terminator 4 or AVT2 IC;s.

THanks y'all.

Jon Brown
Anybody that tells you that a Rotel amp is "warmer & smoother" than a Sunfire is either a bold-faced liar or speaking out of lack of experience with both product lines. The Sunfire is specifically voiced to sound slightly soft in the upper mids / lower treble region. Bob Carver was not shy about admitting this and it has been commented on in several different reviews of these amps. Sean
>
Sean -
From what I've heard, I have absolutely no doubt that, due to the voltage & current source connections on the Sunfires, they are smoother than the Rotels. My audition this evening of the Rotel RMB 1075, driving B&W 704s, yielded a very smooth, very laid-back sound. I was altogether pleased with the sound of the amp, which is why I ordered one, to be picked up Monday.
I saved some money, and like I said, if I don't like it, then I'll either put it elsewhere or sell it and get the Sunfire!

THanks all,
Happy Listening!

Jon BRown
Do you know what cables the B&Ws were being fed with?
I'm interested in your 1075 experience as it is a fair priced amp that may be a bit better then the older 985. I'll audition the 985 this week and hopefully be the owner by early next week. I'm not holding my breath though, I'm picky! haha