Rotel 1075 5-Channel + Rotel 1068 pre/processor

Unfortunately the Rotel is not likely to perform quite as good as your older Classe set-up. This being said you can make it sound as good as possible. Playing with bass management on a pre-pro can help substantialy just as playing with speaker and sub placement can. After all of this has been done until you are sick of adjusting you can try all of the magic tweeks. I think that if you try a PowerVar or Trip-Lite power conditioner on your CD player or turntable you will see an appreciable difference in the bass reproduction. Because these sources consume little current you can use a small conditioner that is relatively inexpensive. Demo one if you have the chance.

Go for Signal Cable. I would recommend the Magic Powercord on all components. Not costing you a fortune, you´ll be happy with the bass response this PC will give you.

For Ic´s and Speaker there is a wide range to fit your needs.

BTW - Let the gear get some hours before judging. Atleast 100h+

Best

Check the sub settings on the 1068. You will need to dial it in 3 categories.

a. Sub Settings (one for each input).
b. Speaker settings ( I use the "max" setting).
c. Test Tone (you will need a SPL meter).

Hope this will help.

I've struggled with these same concerns. I own Rotel 1066 processor and 1075 amplifier on B&W speakers. I haven't replaced power cords, but did upgrade speaker cable and interconnects hoping to increase bass response. It helped, but never to a level that compared with good 2 channel components. I turned the bass tone control up to +4 on the Rotel, and now I'm satisfied with the way HT sources sound, but still not 2 channel.
I've experimented with integrating a separate 2-channel pre-amp into my HT setup, and that yielded some very good results (and also made me want a better amp). To integrate a separate pre-amp, you would hook up the main outputs from your Rotel into a HT bypass input on the 2-channel pre-amp. Then the outputs from the 2 channel pre-amp go to the inputs on the amplifier. Any two-channel source would be hooked up to the inputs on the better sounding pre-amp.

Good luck. For me, I'm leaning towards two separate systems. One for HT, and one for stereo.

Thank you for all your responses. I think I'm more confused about everything now than before. My previous two channel set up consisted of the Classe Seventy amp paired with the Classe Four preamp (a bit dated but still good). I was originally going to sell the Classe equipment, but after hearing the newly acquired Rotels, as I mentioned earlier, I'm a bit disappointed, especially with the two channel stereo bass response (non-existent!). So if I decide to keep the Classe equipment, how do I incorporate it into my Rotel equipment? I tried to follow what the last posting recommended (incorporating the pre-amp into my Rotel, but got lost on exactly how to hook it up...Or should I try hooking the two channel classe into the 1068 Rotel processor for the front speakers? If so...how do I do that? I originally had wanted to add a new power cord. A previous post had recommended Signal powercords. Upon closer inspection, the Rotel equipment only takes a TWO PRONGED North American cord. Now I feel like I've bought the wrong equipment; what decent stereo manufacturer only uses TWO pronged power cords??????. *sigh* Does anyone make a decent two pronged power cord? In the end, the VERY last thing I want to do is have two separate systems...one for HT and the other for strictly music. ANY and all advice is greatly appreciated!