Ways to clean up the wall power for SET amp?

You may ask George Wright what he thinks, but I personally have found that, with the low-powered tube amps,cleaning up the power and or slapping on a power cord that costs as much as the amp does not make any difference to my ears. Those same things do make differences in the front end though. If I were going to invest in power for a tube amplifier, I'd invest in a dedicated circuit with an isolated ground and a good outlet. Just my opinion, of course. Worth all of .02 cents back in 77, while in the current economy I actually went into debt by sharing it with you!

Marco

put a bybee on the + leg from the IEC to the transformer inside the amp.

worked well on my wavac.

rhyno

I dont have a Set setup, (then why reply?) I can tell you the dedicated circuits with the I/G made more of a difference in my system than any power cord. I had the work done by pros, they ran a #4 ground wire out of my house into a pole burried 6 feet in the ground with a few 20 amp dedicated runs back to the fuse pannel. The cost was what I would have paid for a pair of decent power cords, but well worth the results.

Since then I have tweaked by purchasing the Cyro outlets, and upgraded again my power cords, but that is just better frosting, not a better cake.