Short speaker cable recommendation

Mikirob, which model of the Arizona caps and where can one buy them? I have never seen then at the usual parts stores like Parts Connextion etc..

how about Belden 1585a?

Grannyring or Mikirob?

Have you compared it to the 8402?

not trying to hi jack the thread but this was recommended to me on AA and maybe should be considered...

Another good source for copper (or silver) in cotton is Jupiter Condenser Company. Their wire has a very natural timbre and great dynamics. You can twist it, braid it, or run it single and it sounds great.

Bill, I am skeptical of how tinned copper might sound but, based on the on-line recommendations by you and others, and on my positive experience with the copper-in-cotton Jupiter wire, I just purchased a bunch of the WE 16awg wire. If the strand count is as stated, the individual wire gauge should be about 29/30 awg. I plan to run two separate star-quad runs to each speaker, thus bi-wiring an aggregate 13 awg to each LF and MF/HF. I will let you know how it works out.

Grannyring,
The Arizona Caps are covered on the Jeff Day Wordpress Blog you
referenced above. Check out the Yazaki-san recommended changes to
Day's system via his capacitor change and update. I think you will find it
enlightening. Yazaki-san use these in his SPEC amp and many 300B
rebuilds. Like their name I believe the Arizona Caps (green/blue) are
located in Arizona, again, I believe Day provides a link.

Yazaki-san also recommends some resistor change to Day that will be
implemented soon. In addition, some tube variants.

I am so thrilled with the cable and interconnect suggested by Yazaki-san
that I too, am going to follow his other suggestions with regard to capacitor,
resistor, internal wiring and tube types/brand as applicable to my situation.
For example, Yazaki-san just sent Day a Haltron 5u4G to try and he and
several friends agreed it bettered the tube in his already superb amp. Now,
Haltron did not manufacturer tubes, but rebrand under their name; trick is to
find out what NOS was it? Brimar? GEC? Or other British Rectifier? This
tube discussion is also on the Day Blog you reference above.

Philjolet, I don't know anything about the Belden1585a as compared to the
Belden 8402. Perhaps I should buy and compare/contrast. Can you tell me
more about it?

I was initially going to install Jupiter capacitors in my redo of the Coincident Dynamo integrated, but now will go with the Arizona. I am likely to also replace the Nomex internal wiring with the WE 16ga?

I have some pretty good NOS Rectifiers, Mullard 5AR4 from 60s, Phillips, that Upscale is pushing, Grant Fidelity Black Treasure 274B, Mullard Fat Bottle coke shape from 40s/50s (saving for when I get the Franks), amongst others in my tube stash, but I am willing to go with any of the Yazaki-san recommendations and test it out, compare/contrast. This would be a lot more fun if NOS tubes were in line with the WE and Belden wire cost.