I asked the same question to MIT and they said that doubling up was just fine. I have been doing this for over 5 years now.
Bi wire to single post question
This may be elementary to some, but I am not sure what to do.
I have a pair of MIT cable that have single post to plug into amp (red and black) that then run to a "modulator" that splits out to a high and low output (I.e. 4 banana plugs, red and black/high and low). I now want to connect these cables to a speaker that does not have 4 post, just two. What is the best way to connect? Combine the high and low output into a single banana plug, making one for red and one for black? Or is there a better way to do it?
I have a pair of MIT cable that have single post to plug into amp (red and black) that then run to a "modulator" that splits out to a high and low output (I.e. 4 banana plugs, red and black/high and low). I now want to connect these cables to a speaker that does not have 4 post, just two. What is the best way to connect? Combine the high and low output into a single banana plug, making one for red and one for black? Or is there a better way to do it?
- ...
- 9 posts total
- 9 posts total