buzzzzz, where did i go wrong?

good night,...I am on the night shift!
jd

one other supplemental thought. the three dedicated circuits should ideally be on the same bus in the panel to minimize ground differentials. also, if possible, this bus should be the one with the fewest amount of large 'noise' contributors from i.r.,dimmers, fridge, etc. this could involve some rewiring in the panel but is usally worth the effort.

I think my fiance soon to be wife is starting to really wonder about me!

Hey JD.......Bob here.The reason I asked you about the neutrals or white wires is that these are also referenced to the same grounding nuetral bar in your main panel.You should have a grounding neutral bar in your sub-panel.Tell me if you fed your sub-panel with hot ,neutral and ground or if you just ran the hot wire to your fuses and did you install a breaker in your main panel to branch from.Back to the neutrals,the grounding bar in your sub panel has a bonding screw through it to ground the enclosure itself.This bond is NOT USED for sub-panels.Also one other very important item is your metal conduit connection if its functioning as your ground consider that the point that it connects to your main panel is likely inches away from the grounding neutral bar and being connected directly to the panel enclosure you will certainly pick up stray voltages.The best way to accomplish your outlet grounds is get the Hubbells or Leviiton Hospital outlets with isolated grounds and run separate wires back to your panel.You can then use your conduit as a shield by connecting it to the panel end only and using a plastic washer on the outlet box(if metal) to isolate it.One more great thing to finish off the grounding job is if you have room in your main panel install an additional grounding bar(these are readily available and designed to attatch to your existing bar) and connect all your new outlet neutrals and grounds to this bar.If you can install the bar as close to your service ground as possible(also you should connect your rods right next to the service ground) this gives your audio circuits the most direct path to earth and minimizes the reaction from the rest of your house wiring.I used to wire houses in my younger days and was close to becoming a journeyman electrician before deciding on another career.Hope this helps and feel free to email me if you like....

Dear all,
thanks for all your inputs. I am unfortunately on the graveyard shift but as soon as I get home I will examine my various panels and subpanels and try to figure it out. I am a bit unsure whether I should be examining high volatage electrical panels after having been up all night but what is life without a little risk.
Sean, on the email I sent you that I think you didn't get I mentioned that some friends and I will be in Chicago on May 8-10 and I think we are going to wrigley on the 9th. Maybe you would like to join us since I think that is where you are from! You can reply by email or whatever. Tix are I think $26 plus tixmaster's damn fee.
JD