2. tech-talk
  3. 1078095955

How do I power up my monoblocks?

I have Kharma 2.1's, Lamm M1.1's, and an Operah Cd player running direct into the amps. I am installing dedicated lines and do not have a power conditioner as of yet. I am considering a preamp, but definatey want volume control. What is the best way to turn the system on? I want to plug the amps into the dedicated lines but find it tedious to turn each amp on from behind. Should I get a power conditioner with a power swithc - If I do does that negate the instalation of dedicated lines? Any way, it may sound like a stupid question but would appreciate advice.

Thanks

Lou
ltobiajr
ltobiajr OP
2 posts
 
The L1 does not have volume remote, right? If you figure out a way to trigger the amps via 12 volt trigger that would be a good start.
I guess i should also ask, what pre out there has remote volume and 12 volt trigger that will meet the level of audio quality.

Thanks

Lou
cytocycle
1,043 posts
 
No unfortuately it doesn't have a remote (no lamm preamp does) and that was a requirement. I just purchased a Rowland Synergy IIi preamp with remote but no 12v trigger, besides the Lamm's require a different cable not the typical 12v 1/8" stereo jack. so all that is required is the special connectors that plug into the lamm and the X10 module that has a 12v trigger and the x10 remote to control it. Should be pretty easy, just haven't had the time.
swampwalker's avatar
swampwalker
5,138 posts
 
IMO, one of the values of monoblocks is that you can position them close to the speakers and use short speaker cables. Then it might be easier to reach in behind to turn them on. Good luck.
rlips
105 posts
 

this may seem like a strange idea, but why not turn your mono blocks around 90 degrees? That will allow for shorter speaker cables and provide easier access to the back.

I saw this done once, and it did not look as strange as it sounds.
More to discover