Power Conditioner for your amplifier?

Amps should absolutely never be plugged into any power conditioner. Hands down best results come from using a dedicated line for each amp with that line having its own ground at the street. I had a long talk with Terry Gordon (National Sales Manager of Audio Research) about this very issue at a time when I was running his Ref 600 MK lll monos. Terry said unequivocally to have each amp in its own dedicated line as a power conditioner would only serve to take away from one's amps ability. I took his advice and have 30 amp dedicated lines each using 6 gauge single stranded Romex wire. Present amps are Lamm ML 2.1 into the same dedicated lines which are now somewhat overkill for an 18 wpc SET. Nonetheleless I would NEVER have any amp plugged into anything except the wall on a dedicated line. My room has 12 other dedicated lines for source equipment

For all other components I do use the Line Source from Jim Weil at Sound Application.

http://www.soundapplication.com

Oneobgyn, I think there would be a substantial difference among amps and the use of power conditioners. The ARC Ref 600s would likely be too much current draw for any conditioner, but my little 8 watt Reimyo would be no problem, In fact Reimyo makes a conditioner and uses it at shows on the amp.

The SoundApplication you mention is in my experience quite good even with big amps. Perhaps not as big as the ARC 600, but I used a SA with my HK Citation 7.1 amps that drove my subwoofers. It was clearly better into the SA than into the wall.

I now have 2KVA IsoClean transformer which should be able to carry the Citation, but I have sold it and no longer used subs.

My findings agree with Tbg's as far as the Isoclean products being suitable for use with amplifiers as well as front end components. The dual transformers and 80A3 line filter are rated at 3 kVA and can handle just about any but the largest amplifiers. For example, I power the Atma-Sphere MA-1s or Parasound JC-1s through the combination to very good effect. Disclaimer, I am an Isoclean dealer.

I do not typically recommend hospital grade outlets because they are often nickel plated, and there are better outlets to be found anyway.

I see no reason why the Audio Research,with associated power needs would NOT go into the outlet directly.That being said,the PS Audio UPC 200's (though not really line conditioners)seem to be a superb solution for many lower power usage amps(even though the UPC 200 does not have current limiting)which will actually clean the line(without filtering)and be an additional source of component protection.What's not to like?

Best!

Gentlemen

I respectfully disagree

Simply put, I would never have amps plugged into anything other than dedicated wall outlets