Power Conditioner for your amplifier?

I have a Pass X350.5, I didn't like the X350.8. But to each his own...
Anyway, I tried so many, many power conditioners with this amp including many that have been mentioned in this thread.
I found that just using a dedicated line with Furutech outlet and a high quality power cord gives me the best results.
However, I do have plugged in to that outlet a Nordost QV2.

To me 350.8 had better dynamics,better stage etc they are both great amps. I don't have dedicated lines i do however have my amp on one line preamp,cd,and turntable on another line with FIM outlets and Furutech covers.My amp sounds much better through the Audience 6TSSD.

The right conditioner will give you fuller body, a silky sheen and more bounce, but don't pay more than 5.95.

On my 1st setup, I use two power conditioners Tesla Powercell (4) ->Tara Labs PM2 as cascade to feed my BAT vk-600se. The result is phenomenal. The main challenge was to find a good power cable with appropriate AC plug metal feeding powercell and Tara labs PM2. Both are non-current limiting power conditioners. For sources and preamp along with TV receiver box, I use same configuration, Tesla powercell+Tara labs AD6.

As for my second system setup, I use a Running Spring Haley which is a very good PC with Mcintosh MC402.

A non-current power conditioner is the one recommended by almost any amplifier manufacturer! the other important factors are power cords as in/out to the PC and AC outlet.

In the past, I tried shunyata Hydra 8 which was not bad, but I prefer Tara labs Pm2 and Ad6.

hope that would help.

For my 115 W Air Tight monoblocs I use Bybee Holographic with great success and wouldn't be without them.