Single Channel Attenuator


I'm looking for a single channel, single ended, passive attenuator. I could build one, but would prefer to just buy it. I would like the cost to be low, under $100. This does not need to be audiophile grade but it can't be of poor quality either. It is being used to set a level for some basic acoustical measurements. Any ideas or products or companies that may have such a device would be helpful.
rives
With respect to Mouser. They are great for parts, especially of very hard to find illumination blubs. But, beware of shipping changes (ask first). If not, you can pay $6.00 UPS to have a $2.00 part delivered. Unless they have changed, they automatically ship UPS ground.
Thanks for the tip on mouser. It seems they are all raw parts, which is not what I need. I need a finished product. Yes, we could design and make it ourself very cheaply, but since I only need about 10 or 12 units and I need it to look finished it's not cost effective to build it myself or have our engineers design it. Looks like the Gibson suggestion will work well--I'll try Sam Ash and some other music stores (perhaps some local ones).
marakanetz...Perhaps RS parts are not of the quality one likes to have in the audio path, but, as a temporary device to determine needed attenuation a RS pot is fine. (And I have never had unusual problems with noise from RS pots, although all pots eventually get noisy and need a dose of contact cleaner..RS again). When the desired pot setting is determined, measure the resistance setting, and replace the pot with a couple of fixed resistors. Surely one wouldn't leave any extra adjustable attenuator device, Mouser or otherwise, in the circuit permanently.
Agree on that Eldartford, I too use RS pots to determine the right value of the resistor and than replace it with the high quality one...