halogen lighting?


I am starting to plan the interior of my listening room, I saw a post here a while ago that recommended against halogen lighting. I would like to get some low "atmosphere" lighting, with a dimmer swtich as well as the "spot" type halogens. Will these cause electrical interference to my sound system?
thanks,
thumper
joeb
To answer Ed's question...on inexpensive halogens, a small transformer is built into each individual lighting fixture, so there is no way to isolate the source of the noise from the source of the light. The Home Depot-type tracks are called "low voltage", but the the voltage running through the track is 110V. The step down occurs at the fixture. True low-volatge systems run 12v through the track, which limits the length of the track run due to voltage drop.
Ok, well I guess that about sums it up! So what's the alternative for lighting? I found a nice set of wall sconces, with a cobalt and red shades but they wanted a ridiculous price for them, like $180 ea.
jb
one alternative would be to use the low voltage lighting system but convert it to pure DC. Some home-brew technical expertise would be essential to accomplish this.
It's easier than that. I installed low-voltage baby halogens atop my window inside frames for dramatic soft lighting of my drapes, but at TERRIBLE acoustic penalty...WITH wall-wart 12v transformers. And yes, they DO radiate into the audio...even when not on the same dedicated lines. OTOH I have in-room incandescents that are dimmed by a normal pot and they're COMPLETELY quiet!
So for $6 just get a rotary or slide dimmer and control incandescent 115 v lights, and leave the low voltage or halogen ornamentals for non-audio entertaining. I'm still surprised at the difference in noise level. I don't even hear incandescent filament "singing", either, from the 40 watt candelabra-shaped bulbs, whereas those baby halogens make muy system sound like my old short-wave receiver!
I have the answer your looking for! We just finished remodling the den, which is where the audio & projection systems are located. My electrician promised me that the low voltage lighting (12 volt) he would put in wouldn't make any sound. Well, I went along with his suggestion, and he was right! He used a unit made by "Elco". I believe the modle number is EL1499R. The cost was just under $26 each at the electrical supply. Each unit has its own transformer, but I can't hear any sound comming from them, and neither can anyone else! The dimmer that we're using is made by Lutron, and is called the "Spacer System". Very cool dimmer; works off an IR remote, and can be programmed for 4 different lighting levels. Hope this helps! Ken