Placette RVC


Hi have any of you connected a Placette RVC to an integrated amp and set the integrated amp to power only mode (switch off the pre section).

I have a Simaudio i3 and looking to do this.

Thanks
acdvd
Actarus
"I just bought a serviced_recapped E-202.
I'm thinking to connect it only to the LINE output of my DAC, so my plan is to access directly the Amp stage of the Accuphase."

If your dac has volume control ability . Why think, just do. It takes all of 30sec to try, I think you maybe in for a surprise.

You'll hear your dac's output unmolested by any colourations that active preamps bring to the mix, that's why they all sound different to each other.

Cheers George
Agreed George, I'll try that as soon as I receive the E-202. :)

I'm still wondering about the second question though... ;)
05-18-15: Actarus
Agreed George, I'll try that as soon as I receive the E-202

I'm still wondering about the second question though... ;).

I don't know this one, being passive I would say no. Unless it has it's own colouration and you like those colourations over going direct.
And it shouldn't colour/distort the source signal as much as actives do.

Cheers George
Ok, I think my DAC has volume control only for the headphones out; not the LINE out. Is it dangerous to connect it directly to the amp stage of the Accuphase?
Is it going to blast 'too much sound' to it?

Thanks for your opinions on this.


No should be fine, as it will be a nice low low output impedance because of a headphone driver opamp, but a normal output with VC would probably sound better because the head phone opamp won't be in the signal path.

Just turn the VC down before you try.

Cheers George