montana eps crossover ???


does any one know where ca i get the schema of the montana eps loudspeaker ???
please help !!!
elin
If your intention is upgrading the crossover components, consider giving George Short at North Creek Music a call. His top line crossover parts utterly transformed a pair of loudspeakers I own. $800 was a big cost for crossover boards, but George fully assembled them leaving only slip-on/eyelet connectors to be attached to the drivers/binding posts. Absolutely the most cost-effective upgrade I've ever made to a system.
Hi Jb0194 and Chadnliz,

I sincerely doubt that Mr. Short from North Creek (funny coincidence, my last name directly translated from Danish, my country of birth - means exactly - "north creek") can install any better cross-over components than the EPS utilizes, both capacitors in the tweeter section are of the film and foil type, especially made for us - aluminium foil/ polypropylene film. The series cap in the bandpass for the mids are a combiantion of a film and foil bypass (10% of the value) and a metalized polypropylene film cap. All inductors are of the perfect layer type, large gauge where appropiate. In many cases a series resistance in an inductor is actually required and an integral part of the design

Yes -I aggee that diffrent components in cross overs may sound diffrent but that is just so, diffrent, not better.

I closing let me plaese point out that designing a Loudspeaker takes a long time, going through a lot of drivers, boxes, components and working with your suppliers to get exactly what you want and therefore at a considerable expense, the final topology of a cross-over I consider to be very propritary in nature and would therefore never release.

Thanks

Peter