wilson watt puppy 7 help and suggestions

Michael,

Do not switch the ports over to the tube ports, those of for amps with low damnping factors (Lamm's don't have that problem). Run the Lamm's Switch at the below 6ohm switch. they are an average at 4ohms with a couple of dips below that.

If you are using single ended make sure to use the short plug on the other RCA for either inphase or out of phase depending on your preamp. Even with the XLR's I believe you must have the short plug on one of the RCA's Sets.

Enjoy!

Thanks for the info on the damping. I thought it would probably not need to be switched but better not to assume.

Interesting follow up on your input regarding the short plug. I checked the manual and the amp is shipped with the short already inserted. The manual says to take out the short plug if you are using balanced xlr.

Michael

I agree with Cytocycle's recommendations wholeheartedly except one: you should listen to both ports with the Lamms and determine which sounds best by your ears. As a long time Wilson afficionado and current W/P7 owner I learned long ago that the ports tune the "instruments" far more to the tastes of the listener than to the specifications of associated amplification.

Khrys: I agree but forgot to mention that I owned Lamms (M2.1 and M1.1's)before I switched to Theta Citadel and the solid state port sounded better. Your time will be better spent adjusting (adding and removing spacers on the Wilson footers will change the bass based on the room inteactions) Remember to change out to the correct Back spike on the Watt since you adjusting the height of the speaker. Of course always put the speaker in the Zone of Neutrality using the WASP positioning method first.

Changing the back spike on the Watt plays a huge role in the mid bass sound. Refer to you wilson manual for both of these adjustments.

Karmapolice: it's been awhile since I changed the shorting plug but thanks for the correction.