For anyone still following this thread I finally received and put into service the ECM8000 RTA setup mic for the Behringer DEQ2496. My plan was to use the auto setup for base room correction first and adjust for my hearing, which seemed right-weighted, afterwards. As suggested in several articles, I decided to do this only for lower frequencies and limited auto EQ to those frequencies below 500hz in the dual mono mode. As I've stated more than several times, I'm not good at discerning subtle changes and, possibly, even more limited in my ability to describe them. The difference, however, that this simple adjustment alone made was obvious even to me. I almost started a new thread titled "it's the room, stupid" the improvement was such a surprise to me.
The apparent and most appreciated improvement is a more centered stage; I no longer have the sensation that what I thought was my stronger right side hearing moving the stage to the right side. The auto EQ reduced frequencies mostly in the approximate 30 to 100 Hz range but resulted in improved clarity in the lower midrange as well. Until I heard it myself I never would have believed that room conditions could have such a significant effect on sound quality.
I'm not saying that a good EQ is the answer to all woes but in my experimentation over the last several months, IMO, it is a good starting point and I highly recommend trying one if for no other purpose, as an evaluative tool. To go a step further, although I found learning to use it was quite a challenge, with the capabilities of the DEQ2496 it should be all one needs to address a wide variety of needs.
The apparent and most appreciated improvement is a more centered stage; I no longer have the sensation that what I thought was my stronger right side hearing moving the stage to the right side. The auto EQ reduced frequencies mostly in the approximate 30 to 100 Hz range but resulted in improved clarity in the lower midrange as well. Until I heard it myself I never would have believed that room conditions could have such a significant effect on sound quality.
I'm not saying that a good EQ is the answer to all woes but in my experimentation over the last several months, IMO, it is a good starting point and I highly recommend trying one if for no other purpose, as an evaluative tool. To go a step further, although I found learning to use it was quite a challenge, with the capabilities of the DEQ2496 it should be all one needs to address a wide variety of needs.