Why shouldn't I bi-wire Wilson Watt/Puppies 6

You'd be bypassing the crossover as well, so in all, not a good idea.

Rgds,

Grant

I haven't seen the latest versions but the earlier ones had the crossovers in the cabinets. Is the 6 different?

I have wp 6's. The issue is you by pass the crossover when done the way you are asking. You can run your Watts full range direct to your amps. The Watt's produce about 90% of the sound. The Puppies the low low bass only.

Bi wiring the speakers this way may cause some interection with both cross overs and and your amp. I'd stick to their recommendation.

b/c of your bannana's at one end, I'd only use one part of your bi wire to each speaker. You'll still get great sound. Order a adapter to hook things up right.

You have one of the best speakers anywhere...don't mess around with using both taps off your amp and hooking up both terminals of the watt and the puppy. The designers did things for a reason....

You'll have killer tunes using only 1/2 of your cables...buy some adapters and be happy...or try some different speaker cables..the wp 6's are VERY revealing...you may/may not like something different...

Jfrech,
The adapters you refer to are from Nordost? Hooked up and running now, sound very good but in no way do I think I'm close to having the speakers setup in position, etc. Just connected a REL studio II that will also need attention to make "fit". I'm so damn tired tonight that I'll just be listening to things as they are:).
Thnx for the input!
Rloggie

The adapters ...not sure if Nordost makes them. Try going to AudioAdvisor.com, they should have something that will do it...several brands I'm sure...