totem model 1 owners

This is what Totem recommends for placing all their speakers, and it's worked very well for me:

positioning is very dependent and experimentation is the key

we recommend a systematic procedure where (with the same song track) you place the loudspeakers 1 foot from the back wall and do small increments forward until you reach the desired spacing

you should focus on bass extension, depth and decay

next place the units 4 feet apart and in small increments further the spacing between them

you should focus on imaging, soundstage and 3 dimensionality

I have a pair of Model 1 Signatures that were set them up using the method suggested on the Cardas website. See: http://www.cardas.com/content.php?area=insights&content_id=26&pagestring=Room+Setup

When the speakers were placed close to the back wall the bass response was more pronounced, however, soundstage (important to me) suffered greatly, especially depth.

I have used them with both solid state and tube electronics (cj Premier 14; PV10A; 2250A; MV50) and prefer tubes all round. Toeing them in very slightly (almost not noticeable) works in my room.

After trying a number of subs, I ended up with a REL Strata II and have been very happy with it, preferring it to the first sub that Totem sold—the now discontinued Lightning. I found that the RELs not only integrate well with the Totems but also with my Rogers LS3/5As.

Depending on the kind of music you listen to (me, I listen mostly to classical and smaller jazz ensembles), you may want to explore the use of Totem Beaks. I have four...their effect is quite noticeable (sound staging especially) on the Totems, but doesn't seem to have an effect on the Rogers. Perhaps it's my imagination.

By the way, after experimenting with numerous cables I chose Cardas Hexlink 5C Golden biwires. A lot of other cables sounded bright with the Totems. That they can sound bright in some sytems is a complaint that I've heard about the Model 1.

i had mine 4.5 ft from the back wall and 3.5ft from the side walls. very little toe-in with target 4 pillar stands filled with sand. i also used odyssey stratos monoblock amps. i also used a rel strata III sub. check out the cardas website to get some insight on where to start the placement of your speakers.

thanks for all the great info!

violaguy, how did the mv50 sound with them? enough power?

interesting that 2 of you had them mated to rel stratas, it must be a good match. did you guys run the totems full range?

thanks again!