New Von Schweikert VR SR4 mk11 Cream or Crap ???

CORRECTION :
Hi guys, pardon my ignorant question but I m confused with the biwiring issue for this speaker. I thought biwiring is a cable with 4 terminations at the end of the cable to be connected to the 4binding posts of the bass module or unless ur saying that the terminations are long enough to connect both the midrange and bass module . As I understd it what ur describing is bicable with 2 different sets of cable. in either case wldnt u still need a jumper cable to connect the lower to the upper binding post of the bass module ?Happy listening tq

The bass module of the VR4Sr's already have jumpers between the two sets of bass inputs. What is recommended is that you take one set of speaker cables from your amp and connect to the lower termials of the bass module, leaving the jumpers in place. Then take another speaker cable and run it from another set of amp outputs on the same amp to the midtweet module. I hope this is clear. You can bire using one cable with four terminations at the speaker end but with the Vr4's you are going to need to have the wire split into two pairs (one for the top module and one for the bottom) in a way that will extend the distance (aproximately 28 inches) between the two modules binding posts.

Gammajo, now I got it. You are basically using the jumper plate provided by the manufacturer. I believe it wld be better to change the jumper plate to a better jumper cable. I change mine to a Transparent jumper cable and its certainly better than the stock jumper plate. Happy listening tq

Audioblazer
What kind of changes in sound did you hear with the different jumpers And about how much do they cost?

Now come on guys. All you have to do is run one pair of cables from your Amp to the bottom spade/bananas.
Run the second set of speaker cables from your Amp to the top Midrange/Tweeter module. Take the cheap jumper plates outcompletly!