Sub Woofer hook up with McIntosh MC 501

I spoke with Albert Von Schweikert concerning this issue, since his VRS/1 subwoofer is the one I will connect to. He states the sub amp was designed to take a load from an amp as long as the connection is made to the high input on the back of the sub. He also states that his Von Schweikert circuits are designed to be compatible with one another, therefore they may be connected in either configuration.

Just quoting what the designer himself told me

All I'm saying is you shouldn't cause the Mcintosh to drive two output ohm taps. I know other amps would have problems.. The Autoformers on the Mcintosh can play low impedences but I'm not sure they will support playing 2 & 4ohm taps at the same time.. put both wires on the 4ohm tap and ground.

I would call Mcintosh.

Upon your advice, I have placed a call to Chuck Hinton at McIntosh. Thanks

Here is a possible solution
With a Vandersteen 2WQ you can safely take speaker
level out at the amp into the pair of 2WQs the reason is it has a safe 1/2 Mega ohm input Imp. You will also receive the benefits of
high Passing the main amps which will lower distortion
and dramatically clean up the clarity of your system and music.

Johnnyr

Spoke to Chuck Hinton at McIntosh, his feelings were it would probably be best not to run the sub and the mac together, although it may be possible depending on how they react to one another, it's not advisable. He did state that REL sub are setup to connect directly to an amp