2. speakers
  3. 1193879557

Need speaker suggestions

I've just about finished my "game room". Ceiling and walls are drywall, floors are wall to wall carpet. I have a really old pair of Cizek speakers(circa 1975) in there for now and I'm using Zone 2(100w/ch I think) from my Yammy receiver to drive them. Other than the pool table there is no other furniture in there now and probably will only be bar stools(with the bar of course) as future furniture. Room is very bright, may add some acoustical treatment at some time....but with the given descriptions what speakers would go well with the "brightness" and the fact that it's Yammy's Zone 2 powering the speakers. I've heard Vandersteens and like them but will they mate well with the receiver's second zone output?
muncybob
chadnliz
3,736 posts
 
While I love Vandersteen speakers and am a huge fan of them I dont feel they will work ideal with a Zone 2 of a reciever, the Vandy is a power hungry speaker and that is the only reason I would caution the choice.
wwshull
157 posts
 
go to the montana audio site and check out there speaker selection
muncybob OP
50 posts
 
Thanks all!.....From what I can determine the receiver(RXV1400) is rated as 110 watts RMS to all channels, so would the Zone 2 be the same since these speakers are connected to the "surround back" speaker terminals. Since I'll never have a sub in this room low end extension is important. Ohms have always interested me but I guess I need to determine what this receiver will drive efficiently?
bondmanp
1,817 posts
 
The Vandy's are usually 6 to 7 ohms nominal impedance. Importantly, Vandersteen speakers tend to be an easy load to drive since their impedance does not vary excessively with frequency (IOW, the "nominal" impedance of a speaker doesn't tell you all you need to know about driving it.) Unless your room is unusually large, the Yammi should push them just fine. I got my 1Cs when I was using a Pioneer Elite AVR rated at 90 watts/channel. I had no problems with loudness. I will say, however, that as I have upgraded amplification (currently using an Odyssey Stratos HT3 rated at 150 watts/channel), the quality of the sound has improved. The 1Cs might be a little weak in the lower octaves, IMHO. Without a subwoofer, I would shoot for at least the 2Ce if you can.
chadnliz
3,736 posts
 
You will probably need to look for a speaker atleast in the 90db efficient range and the higher the better.
More to discover