Well- That would bring your tweeter in a little above 10kHz, and your mid- right about 4kHz. The mid isn't doing much midding that way. I'd say 80uF on the mid(500Hz) and about 5.5uF on the tweeter(about 5kHz). I suppose if you were to go with an iron core inductor on the woofer, you wouldn't have as much insertion loss(though it may become non-linear at high input levels). If I were doing it, I would use either Solo or Alpha-Core air core inductors(very low insertion loss and phase shift, very transparent). The value of the coil would depend on the impedance of course(8ohm=2.5mH, 4ohm=1.27mH for 500Hz). I suppose a .13mH to roll off the mid at 5kHz wouldn't hurt either. You may find yourself having to pad the tweet and/or mid to match their outputs with the woofer.
