Emerald Physics CS-2, Opinions Please

Nice pictures on your system pics. They look a bit lumpy back there but I guess that's the way it is. Mye stands or Sound Anchors (if available) would greatly benefit here.

I have tried a few different amps (both tubes and solid state) on the CS2's and while they have sounded good to excellent, I will say that your amps better have a low noise floor, especially tube amps.

While you don't need a lot of watts, at 100db (which I am honestly not sure how accurate that measurement is - I have a 96db pair of speakers and they seemed to play as loud or louder with the same setup), you do want to feed the CS2's as high quality amplification as possible.

The best combination I have found amp wise probably isn't the most practical, but for my tastes it is the cat's meow!

Atma-Sphere M-60's on the tweeter and Bella Extreme 100's run in pentode mode on the woofers. This four tube mono block configuration uses 38 tubes in total and I don't even want to think about my electricity bill. :-(

While I won't say the CS2's are the best speaker I have heard or owned, they are very good and hopefully they will be more than the flavor of the month.

George

Tvad,

If you are in the Boston area you can hear the CS2's at my place.

George

Kck- You may call it "threadcrapping" (new term to me but I am way too old to be a digital native); I imagine Tvad calls it healthy skepticism seasoned with a soupcon of cynicism. I don't think any insult was intended, but then again, neither of us is a direct party to the exchange. If peacemaking w/o apologizing is the same as agreeing to disagree, then I'm all for it. In fact I'm all for peacemaking in any form. This is not that serious an issue. For me at least, its like having a beer with folks of similar bent; friendly "arguments" discussions, whatever.
As our friend warrenh would say; peace.