2. speakers
  3. 1226266302

Think I blew a driver on my Vandersteens 5A

Well, just noticed that my right channel is clearly not as loud as my left. I finally bought the analog Radio Shack sound level db meter. I really should have had one all along. It seems to be an indispensable tool. BTW, I have separate left/right gain adjustment on my preamp. So, after doing the measurement w/ the meter, I am 20db + higher in the left channel. 62db vs.82 db at below average listening levels.
Then, I went ahead and unplugged both sub amps, to eliminate the variable of it being a blown Vandy sub amp. Still, no changes w/ the meter. Then, wanted to eliminate the TT,cartridge... Played a CD, still, no changes. Had to go to work, so my troubleshooting has come to and end till later tonight. Next, I think I will run my CDP direct, to see if it may be the preamp. I would think after that, reverse the speaker wires, which of course would indicate a blown driver if the imbalance does not switch channels. I am just thinking that a 20+db difference will likely be a blown tweeter or midrange driver. It seems to be a alot to think it could be a tube in the amp or preamp. BTW, output tubes in amp bias fine.
fjn04
trcnetmsncom
431 posts
 
Hello Fnj04,

Why not at a very low volume and with a mono recording just put your ear right up to each driver? Also/or try putting your finger tips on each driver while playing music to see if it vibrates?

Good luck,

Tom
fjn04 OP
1,561 posts
 
Stingreen, I will flip the speaker cable from the left speaker
to the right, but may just start w/ running the CDP direct. I would like to just eliminate the preamp, and isolate it to the amp or speakers.

Tom, also a great suggestion. I did not think of that at all. I will dig up a mono vinyl recording and give it a shot. I may use cotton gloves if I touch the drivers, as it may not be good to expose the skins oil... directly to the drivers. Thanks much to the both of you.
zargon's avatar
zargon
453 posts
 
It is very easy to hear each of the three drivers. No need to touch them. Just move your ear up and down. It will be quite obvious if one isn't working.

It is quite likely that the problem lies in something else. It could be as simple as a poor connection or soldering joint in one of the cables.
fjn04 OP
1,561 posts
 
Thanks Zargon. I may start there, seems pretty painless. I have extra speaker cables to try, and will recheck the pre>amp IC connection. I do have another IC which I could try there as well.
trcnetmsncom
431 posts
 
Hi Fjn04,

Any luck yet? You don't even need to use a mono recording. Any recording with a centered voice or instrument will do. Also, don't laugh now, but use the same ear, you would be surprised how differently your left/right ear hear from on another.

A bad connection with a i.c. or s.c. doesn't make sense to me, then the whole side would be out or intermittent not just one driver.

Good luck,
Tom
More to discover