Break In Your Speakers...... What CD and how long?

My advice is to put on your favorite albums and let them play through all day at a reasonable volume. Take some time every now and then to sit down and do some critical listening, looking for a more "full" sound. Most speakers will sound "tight" and "hollow" right out of the box so feed them plenty of hours before judging whether they're worth keeping or sending back.

As far as I know, there's no quick-and-easy way of breaking in speakers. This is why many prefer to invest in used speakers.

I have a cd from Granite Audio that has a full sweep of tones from 20 hz to 20khz. Not sure if it speeds up the burn-in process. I do find that after looping on the slow full range for about an hour my system does sound a little different. I also have the low end test cd too that I loop the slow 20 to 200 hz signal. That helps in blending in a sub if you have one and finding any vibrations in your home.

I found when I got my new Dynaudio C1's they took about 200 - 250 hrs to fully break in. I ran mine 24/7 for about 350 hrs but did not hear any changes after 250 hrs. They did sound great right out of the box but between 50 - 100 hrs all I could ask myself was why did I buy these for so much $$ (head slap). At 100 hrs they sounded very good again then at 200 hrs they were great again. Now at night I did turn the volume much lower and turned them up when I went to work. Now I wasn't happy with the cabinets of the first pair but at 200 hrs they sounded great. The second pair arrived 2 weeks later and that's when I used the Granite audio cd at night and when I wasn't home. The second pair of speakers took about 250 hrs. Dynaudio told me the break-in time was between 200 - 300 hrs. So I don't know what effect the burn-in cd had other than between 100 - 150 hrs they sounded horrible instead of 50 -100 hrs.

Some will say to set the speakers up normally to get to a reasonably loud level then put the speakers face to face as close as you can then reverse the wires on One speaker to put it out of phase. It will sound quieter because they are out of phase but do not put the volume any louder. I read about this after my speakers were broken in so I personally never did try that way.

Matt,

I think there are some break-in CDs available, but I've never used one. I typically just use an up-tempo rock cd.

You can greatly reduce the overall time of break-in if you can play the speakers around the clock for a few days at a time. For me, this typically means using "the ol' out-of-phase trick". Wire just one of the speakers backwards (+ to -, - to +) but leave the other speaker wired correctly. Now face the speakers directly at each other (tweeter to tweeter). Get them as close together as possible without touching. Now when you play music, any like signal sent to both of the speakers will cancel each other out and the overall volume you hear is greatly reduced.

A few extra hints: If you can play a mono signal to both speakers, the amount of cancellation will be much greater. You can cover the speaker pair with blankets, quilts or sleeping bags to further reduce the volume of sound in the room.

Before you do this, make sure you know at what volume position the sound is normally loud using the CD you are going to choose for the break-in. When you perform the break-in using out-o-phase, don't exceed the position on the volume knob that you knew was loud when the speakers were wired normally. This will prevent you from over driving the speakers.

Enjoy,

TIC

Put on music that you enjoy. Sit in front of the speakers. Listen to the music as long as possible each day.

Enjoy the changes in your speakers as they unfold. It is like a child growing up. You don't love them less for their inability to do certain things when young. But overcoming those inabilities as they change allows you to revel in their later accomplishments.

"Instantaneous" (in our case days) break in robs you of the full emotional circle of owning audio gear.