Where can make power cord be detachable for LS15


I like my Audio Research LS-15 pre-amp. I want to use a better power cord to replace the permanent factory power cord. It seems need remove the original power cord firstly, and make a hole to fit the AC Inlet. The work is hard to me due to I have not the special tools.
Where or which store could help me make it in Los Angeles area. Appreciate some one can let me know!
skysound
The later versions of the LS15 had a detachable power cord, different caps, and an upgraded power supply. I sent mine to ARC and they did all the upgrades but would not make the power cord detachable. That was about 10 years ago.
Ebm, what tools did you use to drill IEC hole and what shop did it?

You can use few methods before sending it to upgrade audio shops:

1. you can get electric power shears $300-ish
First, mark the perimeter for incertion of IEC plug, than drill a hole within perimeter with hand held drill. Use portable nibler such as Trumpf Portable Metal Shears to work around perimeter. You can use ruler to pivot the cutting chisel.

2. Probably the most accurate and accessible method using circular diamond cutting disks for your hand held drill. You must be able to remove the rear pannel for safety and cut each straight line with cutting stone first from inner side where the tolerance for imperfections is substantially larger than outside and cut every line with slight overlaps beyond marked perimeter corners while outside leaving small breakable gaps. Knock off the plate and finesse the hole with file to look smooth. You can lock your drill into the clamp(if such available) and work the rear plate around the cutting disk

3. you can simply purchase power-grip wood-works chisel $12 with diamond tip and gradually work to cut chassis using metal ruler or strip for pivot

4. You can bring removed rear pannel directly to the sheet-metal shop or welding shop to cut this hole perfectly...

Power-shears are pricey, but if you will be able to rent them for $25/day you'll make hole in no time.
There's also slight room for error or imperfection behind IEC socket flanges.
Might be best to just trade for the later version. The cap and power supply upgrade was relatively inexpensive, and very worthwhile.
I had this done to an earlier ARC pre an SP6B. I had it done by an experienced tech. This seems to me the most direct and practical way to accomplish this. Since IECs are shared with the computer world there may be more people who understand power supply IEC work than may first appear.