Scanspeak 10" driver replacement - blown woofer

In prior communications; I've recommended to Mike that he contact Bill regarding his speakers. I've purchased cones and surrounds from Bill in the past, but I'm not intimately familiar with his work. Our conversations HAVE always shown him to be knowledgeable. You stated that he changed the sensitivity and excursion of the drivers mentioned. If the changes were audible: That would not only change the Fs, Qes and Qms(which will change all the other system Q's yielded in the T/S formulas and the Vas), but would also cause a rise and overlap in the frequency response at the designer's crossover point. Like I said, changing the designer's original performance goals is not everyone's desire. Most of the higher end speaker builders(especially those that have their drivers custom made), hold the manufacturers to more stringent tolerances than you obviously think. Otherwise there could be no unit to unit consistancy in reproduction.

if i knew which driver i can build or rebuild drivers. Everybody who are talking about change of T/S after rebuilding driver can relax and chill out. Noithing will cange if the same VC, the same weight/qty glue, the same VC height in gap adjusted and of course the same original surround and spider are used if needed to replace. after rebuilding spider can be softened mechanicaly to speed up burn in.

Thank you for your confirmation.

Rodman99999, "Most of the higher end speaker builders(especially those that have their drivers custom made), hold the manufacturers to more stringent tolerances than you obviously think. Otherwise there could be no unit to unit consistancy in reproduction."

Sorry, but you could not be more wrong.

A lot of high-end audio manufacturers wrestle with this all the time. One of the (household name) loudspeaker driver manufacturers supplying Bud Fried with product in the mid 1990s, and part of the business arrangement was that they used to send a group of measurements/plots of the units shipped to Fried. Bud began to suspect something was askew, though the company insisted that they stood by their figures. And, I guess in most situations, nothing more would come of it. Except that Bud wasn't the type to just let it go. So, being that he visited Europe 3 - 4 times per year, he dropped in on them, and demanded they measure the drivers of the model they were shipping to him in his presence so that he could confirm everything was as they said. Well, they soon found themselves in the position where they had to admit the numbers were fudged.

I'm glad you have patronized Bill in the past. On his knowledge, customer service, and workmanship we can agree.

The companies I'm referring to test every driver for consistancy/tolerances, plus match the drivers for use as pairs. BTW: What you just posted as Bud's actions concerning the source and quality of his drivers confirms what I said of, "most higher end speaker manufacturers"(ie: "He couldn't just let it go") KUDOS to Fried!!