Dynaudio Focus 360 - Thoughts/Experiences?

A couple of months ago I was at a Dyn dealer to audition a pair of Confidence C1s. In the same room was a pair of Focus 360s. They were powered by T&A pre/ power and cd. The T&A setup has a rather taut presentation with a solid control. To my ears the 360s were a bit bloated. Of course I was comparing them to the C1s at the time. I spent about an hour with the C1 and only about 15 minutes with the 360s.
My personal recommendation would be to look for a used pair of Contour 3.4. In the past I had a pair of the 1.4s driven by Simaudio W5; a very good match. Has your wife seen a pair of the Contour 3.4s in person. They have narrower footprint and may be easier to integrate in the room from a design perspective.

*Addendum: Correction of course - 4k, not 4 "grams." Sorry for the typo!

Valinar: Thanks very much for your thoughts. Strangely enough, it was a visit some time ago to a St. Louis audio shop that we too had an opportunity to hear a pair of Contours - 3.4. Simply stunning to my ears - well balanced presentation, transparent, wonderful staging. Finally understood what all the fuss was about w/ the esotec tweeters. This was also paired with a T&A power plant. My wife, however, shut it down due to aesthetics. Didn't care for the "modern" look, and wanted something more traditional. Thus, some of the interest in the 360s, though again, have not had an opportunity to see or hear.

The Focus 360 is a unique speaker in that it is part of the Focus line but uses the "Esotar" tweeter that is used in the Contour 5.4's and Confidence products, so it is crossover speaker you might say. I think what Valinar may have experienced at that same dealer was a pair of 360's with very few hours on them. The 360 is incredibly revealing, even more so than the 3.4 which is very well balanced but more forgiving of lesser electronics and recordings. Set up properly the 360 will astound you with a huge soundstage and dynamics but amazing detail.