2. speakers
  3. 1274158422

Klipschorn Imaging

I have a pair of 1980s klipschorn for about a year. I have not heard anything sound this large or so dynamic, but for about a couple of months I have been trying to get them to image well and I am failing.
I have Onkyo TX SR806 (I have some HDMI sources) with pre amp out to MiniWatt 2.5 watt tube amplifier.
One is in the corner flush while the other has wall only on one side (no chance of getting a wall there and false corner likely will look bad).
I have tried using Sonic Impact T amp and that did not provide any imaging either.
The room is 25 ft by 25 ft with the speakers about 10 ft apart.
Is this just the nature of the speaker or has anyone been able to achive good holographic imaging?
Thank you for your inputs.
blueacara
blueacara OP
15 posts
 
" 2cnd is the polarity from amp to both speakers correct

3rd put you ear to each tweeter make sure they are working

4rth compare each speaker and see if all the drivers are the same polarity and terminals match at the barrier strip. "

How do I find out if the polarity is right from amp and how do I check if all drivers are same polarity?
How do I know if it is time for new crossovers?
I am sounding very newbie probably because I have a lot to learn- do enlighten me.
rrog
1,958 posts
 
Have you tried the Onkyo by itself instead of using it as a preamp? There is always the possibility you have a bad match between the Onkyo and your amp.
blueacara OP
15 posts
 
The Onkyo has a high noise floor and sounds brittle, harsh, like a bad solid state from 1980s. It works out well with much less sensitive speakers. The pre- amp section is also not the greatest-not super quite & I suspect the DAC is not the best. I don't have any other significantly better DAC to compare it to. Most of my sources have HDMI out. There is no stereo preamp with HDMI in.
orpheus10
8,668 posts
 
Honestly, you sound like you are where I was in the late 80's. If you are a serious audiophile, I suggest you develop a comprehensive plan. Start by auditioning any and all the components you might consider. 3D imaging require all components functioning as one. This is what audiophiles strive for, and it does not come easy.
rrog
1,958 posts
 
Blueacara, I find it hard to believe your Onkyo receive has a high noise floor and sounds brittle. What is your source and cables?
More to discover