2. speakers
  3. 1447486173

B&W 803D crossover caps

I am considering an upgrade of the crossover capacitors in by B&W 803Ds, particularly the mid and HF coupling caps.

I took out the top bass driver to find out what caps were installed. It looks like for the diamond tweeter B&W uses a Mundorf Supreme silver/gold, 4.7 mfd 1200V. For the mid driver there are two; a 47 mfd Mundorf MKP 400V series coupling cap (in series with the driver) and a 10 mfd Mundorf Supreme siver/gold bypassing cap (parallel to the driver).

I was thinking about changing out all three, but have a few concerns.

I was going to replace the 10 mfd, 4.7 mfd Supreme silver/gold with Supreme silver/gold/oil. Would there be enough of a difference in these two types to justify the cost? I also do not want to make the upper end any brighter.

I am also concerned about the long term reliability of oil filled caps, as some failures have been reported in warmer environments. I wonder if B&W did not use the silver/gold/oils for that reason.

The biggest impact I suspect will come from the replacement of that series 47 mfd MKP. I would probably use either the Mundorf MCap EVO (Al metalization), MCap EVO oil (Al/oil), or the MCap EVO silver/gold/oil. All three are the same size for 47 mfd, and will fit to replace the MKP. Barring the issues about oil, which might be the best sounding? Again, I want to avoid too much enhancement of the upper midrange.
dhl93449
dhl93449 OP
455 posts
 
Dover:

I would like to maintain the stock look if at all possible. Relocating the XO to the outside, well, you might just as well build the XOs from scratch then. No for me at this time. I agree that relocating them outside the cabinet would remove a lot of component vibration issues that XOs face while mounted inside.

The Dueland resistors will not fit the stock layout, as B&W uses radial lead (not axial lead) power tab type resistors with heat sinks. Their power rating of 100W is also way above any Dueland power rating.

Only an EVO 47 mFd SGO will fit. But I agree that one should be replaced first.
dover
2,247 posts
 
I have also used the Mundorph M-Resist (20w) with good results.
Have you considered redoing the crossovers on new boards with point to point wiring and better component layout to reduce interaction ?
dhl93449 OP
455 posts
 
Dover:

In a word, no.

I had only planned to replace a few caps, not rebuild the entire cross over. I don't think that a rebuild is sonically warranted at this point.

I am hesitant to replace 100W rated components with 20W versions, no matter what the sonic results MIGHT be. Perhaps with a 0.5 ohm resistor a 20W might work, but I have not done the power dissipation analysis to confirm.
ptss
1,964 posts
 
Dhl I did move the huge crossover in my 1985 JBL 250Ti's outboard to great effect. Perhaps you can consider ways of isolating your XO within the boxes, although I feel B&W are respectful of this benefit as previously they advertized the benefit of having the XO in the bases of top speakers. By the way what are your feelings re: bypass caps?
grannyring's avatar
grannyring
6,504 posts
 
The best sounding resistors by far are Path Audio folks. Tried them all and these are special. Not cheap, but very special! Look into them and be impressed.
More to discover