projector surge protection

Looks like James is gone, I'll add this for anyone else looking at the projector issue. I had one that a power outage damaged. When the power went out and didn't come on for several minutes, the heat that was being removed by the fan just sat inside and cooked the LCD panels and polarizer.

It started showing up shortly after as a large ugly blot in the middle of the screen. I can't say that I know if all pj's are at risk for something like this, but I got a UPS after that, and plugged the pj into that, running a cord across the ceiling tile and down to the projector.

I'm still around. Im planning on using a upc either a "wall wart" plugged into the ceiling outlet or run an extension from my central power conditioner that all my av plugs through the ceiling. The question is what have others done? Thx guys for the input.

A UPC? Is that a uninterrupted power conditioner or something? If it's a wall wart, it's not uninterrupted, perhaps I misunderstand you.

What I described above looks like a large power bar/surge supressor. It has an actual battery built in that stays charged, and in the even of a power outage, the battery circuit provides 120v so a projector can stay running and it's fan keeps removing the heat. You can safely shut off the projector until power comes back on to the other components and you can resume your movie.

I also have a wall wart style surge suppressor for the treadmill. A great idea for surge suppression and it works just fine, but it can't provide any power to a projector should the power fail. In that case, the projector would immediately shut off, and the bulb heat inside does not get removed.

Sorry for the long explanation! So my UPS(uninterrupted power supply) unit sits out of site, and I ran an extension from it up into the ceiling over to my projector so it's protected from power failure and power surges too. Hopefully others can chime in although it seems Audiogon has few members with home theaters.

Runnin

Thx for the info. That's exactly what I had in mind too. I use a quality power conditioner/stabilizer already but it isn't battery backed. Thinking of using an apc 1250/1500 with the conditioner plugged into it and the electronics then into the conditioner.

Have been using a 20a Torus with my JVC X-90 for quite a few yrs and no problems yet.
Of course she has a few mono blocks connected also amongst a few other components.