Raul,
Dentdog asked you to butt out. Do you know what that means?
It means, for whatever reason he does not want to hear further thoughts or comments on the subject from you.
Sincerely,
Need New MM Cartridge Recommendation
Hello All!
I need a recommendation on a new moving magnet phono cartridge.
Here's my system:
Roksan Radius 5 (I think MK1 or 2) turntable
Creek Evolution 100A integrated amplifier with Creek Sequel MM board
PSB Imagine T2 loudspeakers
The Roksan came with a Roksan Corus Black MM cartridge, which was likely a Goldring manufactured cart. It was great! The stylus broke off after about 8 years use.
I was wondering about the following but am open to all recommendations:
Clearaudio Maestro (yikes! It's $1200)
Ortofon 2m Black
Goldring carts similar to Corus
Audio Technica AT150MLX
Any insight and recommendations will be super appreciated!
PS: Sequel 40 mk2 MM Phono pre-amp is the device specifically suited for most types of Moving Magnet cartridges, with an output between 3.5 to 5mV and a matching impedance of 47k Ohms.
I need a recommendation on a new moving magnet phono cartridge.
Here's my system:
Roksan Radius 5 (I think MK1 or 2) turntable
Creek Evolution 100A integrated amplifier with Creek Sequel MM board
PSB Imagine T2 loudspeakers
The Roksan came with a Roksan Corus Black MM cartridge, which was likely a Goldring manufactured cart. It was great! The stylus broke off after about 8 years use.
I was wondering about the following but am open to all recommendations:
Clearaudio Maestro (yikes! It's $1200)
Ortofon 2m Black
Goldring carts similar to Corus
Audio Technica AT150MLX
Any insight and recommendations will be super appreciated!
PS: Sequel 40 mk2 MM Phono pre-amp is the device specifically suited for most types of Moving Magnet cartridges, with an output between 3.5 to 5mV and a matching impedance of 47k Ohms.
- ...
- 57 posts total
Following this with interest. I've just sold my DV20X2.Perhaps not the smartest move as I have no criticism of it in my RP10, at all. BUT, having seen the performance I can get from cartridges much, much further down the food chain ( A Grado GTE+ . Fantastic, Love It, but can't kill the hum) my DL103PRO ( I always go back to it in the end ) I too am looking for a decent MM, to go with my RP 10 .The option is always there to stick the tungsten C/W onto get the mass up for the DL103, but its 8 years old and the clock is running out. Phono stage is FULLY configurable for gain/capacitance / RIAA curve/ input 'Z' The RP10 makes HUGE differences to the timbral qualities of the music, which is why I'm less fussy about the money spent on a cart. My Totem Dreamcatchers are where I'm at. Bright, musicians would say sharp, like a cold clarinet, until they warm up and settle down after 20 minutes or so. Thanks for this, and do share if you have any further reflections...... |
@fleib
I need to force myself to remove Stanton 980 LZS that i currently use with ZYX CPP-1 (cryo Pre-Pre Amp) on Reed 3p. Never expected that Stanton can be so good, love the sound. |
Dear peeweekiwi: I think you have many options to choose and depends on your budget. These are all very good performers ( you can't go wrong with either. ) at very fair prices: https://www.audiogon.com/listings/cartridges-sumiko-blackbird-homc-one-owner-low-use-serviced-by-nee... https://www.audiogon.com/listings/cartridges-linn-akiva-low-output-moving-coils-cartridge-lyra-koets... https://www.audiogon.com/listings/cartridges-dynavector-xx-2-mkii-2016-04-11-analog-01227-dalton-ma Regards and enjoy the music, R. |
- 57 posts total