Determining current flow to install "audiophile" fuses.

In terms of Newton's Inertia law with applied theory of limits:
If consumed lots of calories of bs per second, i agree it’s very hard to get rid of those calories. Under Inertia law one will continue consuming bs even if no external force is applied.

Czarivey wrote,

"In terms of Newton's Inertia law with applied theory of limits:
If consumed lots of calories of bs per second, i agree it’s very hard to get rid of those calories. Under Inertia law one will continue consuming bs even if no external force is applied."

Apparently somebody's been consuming a lot of Bunnahabhain Scotch (bs).

Geoff,

We’re in agreement that a shielded interconnect presents two variables which are potentially at odds with each other - the recommended directionality based on the which end the shield is grounded to vs. the grain orientation of the wire.

In bringing up shielded interconnects, I saw no mention of them earlier in this thread. It’s entirely possible my mind was numbed from reading it. I’ll take that as a hint that it’s potentially making me stupid and I’ll get back to my amplifier project before further damage ensues.

Thom @ Galibier Design

Thom, no harm, no foul. These guys beat you to the punch in this thread. The shielding argument is probably the leading argument used by skeptics of wire directionality. Followed closely by oxidation on contacts removed during test, placebo effect, expectation bias and a change in house AC voltage.

Atmasphere: "There can be reasons why a cable has directionality (mostly having to do with how the shield is constructed; this has nothing to do with fuses)."

Mapman: "Right my understanding is the reason the Monster wires are directional as indicated is because of the shield implementation. That’s pretty much the only reason that I have read of. My MIT wires have no indicators and I can’t say if it matters or not there. Fuses are a different story. Most high end audio fuse makers seem to leave a lot to the end listener’s imagination."

Georgelofi: "Yes you are correct some interconnects can be directional, ones that have +&- conductors with a shield, that’s only connected at one end, that end should be at poweramp.

But fuses are not shielded. And I still ask you or anyone else to post any manufacturers ad/doc that SAYS they are directional. "It’s all VOODOO" that you are promoting."

Cheers,

Geoff Kait
machina dynamica

Thom wrote, 

"...and I’ll get back to my amplifier project before further damage ensues."

Speaking of amplifiers, assuming for the sake of argument that all wire is directional, imagine how much better Amplifier A would be if all internal wiring was connected with directionality in mind.  Point to point wiring, transformer wiring, capacitors, resistors, etc. And of course all cabling coming into and leaving the amplifier.

g