Phono cartridge advice


My turntable is a Garrard 401 in skeletal plinth, fitted with an SME3009 series 2 imp arm (fixed shell) with a Shure V15vxmr cartridge and a Trichord Dino MM/MC phono stage.  The stylus on the V15 was broken my cleaner!  My question is should I shell out on a new Japanese Jico stylus (which has had very good reviews) as Shure no longer make this stylus, or should I get a new cartridge, if so, what?  I have been looking at the Denon DL110 moving coil, but how will it compare to the V15vxmr?  The Jico stylus is very expensive  (£350GBP) so the Denon cartridge would save me a few pounds but I don't want to be disappointed.  Because I have a good phono stage, I could consider a more expensive lower output MC cartridge but if the cost is approaching that of the Jico stylus I may as well just buy one of those and continue with the V15. So, in short, do I replace the stylus or will the Denon cartridge be a better bet and save me money ... or is there another MC cart that would work well in the SME arm and offer an improvement over the Shure?  Thanks in advance for any help. Les.
128x128lesadams
I have owned and used the following Denons:

Dl110
Dl160
Dl103
DL301mkii

All of their cartridges are very enjoyable. They are not the last word in resolution but are very musical

My favorite is my 103 in an ebony body. It comes very close to higher priced MC but at a much lower price and is the best value out of all the above.

The 301mkii is my next favorite, then followed by 160 and then 110. The 110 was a scream of a value when you could get one from Comet for $89.00. At over $230 it is not as good a value and you would be better of with the 103, which at its retail price is still one of the best values in cartridges today.

That being said, many people swear by the Jico and believe that it is a good upgrade. In any case, both options are credible but if you go with the Denon consider the 103 and then modify the body. You won't be disappointed.
How about the Audio Technica AT150MLX? The ML stands for MicroLine, and it's reputedly the same cut as the Shure MicroRidge. Plus it's on a boron cantilever (boron is lighter than oxygen) with all PCOCC internal wiring including coils. Great tracker, retrieves good detail, very dynamic, reasonably affordable and still in production, which means the replacement stylus is too.
While I agree with the AT150MLX recommendation in that its tracking ability is superb, one needs a tonearm that can accommodate very fine adjustments in all parameters to get the best from its MicroLine stylus.

Having lived with a AT150ANV fitted with a MLX stylus for a few years, it has become an involved love affair in that the MicroLine stylus needs a close hand in fine tuning if every album is to sound its absolute best and a VPI unipivot tonearm accommodates this very well.

A lesser extreme stylus profile might be better for those that want to not be constantly adjusting azimuth/SRA because the MicroLine stylus will quickly expose difference's in pressing attributes but when it's dialed in for a particular record, the results are magical!
OK then. How about a Shelter 201? Rather than spending the $258 needed to replace my AT150MLX’s stylus, I sprang for a Shelter 201 from a Japanese vendor on eBay for $167. I’m *really* loving this cartridge. More dynamics than any .3x.7mil elliptical stylus mounted on a tubluar aluminum cantilever has any right to be, I’m astounded by this cartridge’s musical ivolvement, transparent and honest midrange, and stunning dynamic range at its price. I think everyone should have one--the budget-minded for its performance for under $200, and as the spare for the well-to-do while their 4-figure LOMCs are getting retipped.

Thank you everyone so far for some very good advice!  My thoughts about the AT150MLX are that in the UK, even ordering it from Japan is is going to cost about the same as a Jico stylus for the Shure, the Same applies to the Denon 103 especially if I am to modify it. I would consider these options if they are likely be an improvement over the V15vxmr with a Jico.... I guess that is a matter of opinion and personal taste, but worth thinking about.

I have been very happy with the Shure and the 401/SME3009/V15 setup is a "classic". I hear people talk about the "synergy" of this combination. However it is always good to try alternatives, so I am still considering my options. So far nobody has said the DL110 would be an improvement, or equal to the Shure so I am thinking I might be better off sticking with the V15 or consider one of the above mentioned alternatives as an upgrade.

I am not familiar with the Shelter 201, but I have looked at very good reviews The stylus is replaceable and it woud certainly be less costly .... but again my worry is how it stands up against the Shure.

For interest and in case it adds any relevance to the choice of cartridge, the other system components are a Quad 99/909 pre/power amp and the speakers are Audiovector M2 floor standing. I listen to a wide variety of music from Jazz to rock and I tend to like a good extended top end, possibly because after 40 years of working in radio and wearing headphones, the high frequencies are not as clear as they used to be!

Please keep the suggestions coming as I am considering all the options. I don't mind spending a little extra if I am going to get better performance than the V15vxmr ... rather that than be disappointed if I try to save a few pounds.