VPI Avenger

Mat, Could you tell us the process VPI uses to put a Hurst motor into a shipped product? Do you receive these motors from the Hurst factory and after mounting/aligning the pulley, directly ship them out? Do these motors undergo some sort of testing before any of the above? If so, what is the percentage of good vs. bad motors you receive? If I were to buy a Hurst motor directly from their factory, and reinstall a pulley, would I then have the same exact motor VPI supplies their customers of their tts?

I have, in the past, ordered Hurst motors and their policy is no returns. How does VPI get around this?

I'm sorry to have an additional post...

I hope Mat addresses my questions above that I feel have merit.

I am miffed by others posting: (I assume that the term (vitriol) was aimed at my posts.)

These questions/concerns I have are valid and weren't presented in any way other than to express them as I have thought about them and  experienced them. I'm certain if I had the chance to visit VPI, I to, would come away with the same positive feeling. My thoughts/concerns are over years of being involved with their products and experiences in contacting them, not by just one visit.

Why the vertical play in the motor stems?
Why the addition of the small brass collars to the motor stems?

astro58go273 posts

I am miffed by others posting

Did you think this was your own private forum?