2. amps-preamps
  3. 126746-12768

How hard it is to replace the rca input on the shindo amplifier?

Hi,
Does anybody know how to replace the rca input in my Shindo Montille Ampplifier?
I bought it used from an AG member. I just discovered that my RCA input was broken. The bass out put from my speakers is distortion. Please give me instruction of how to do it. I already order the Switchcraft RCA jacks which Shindo Used for their amp.
Thanks in advanced.
Calvin
dangcaonguyen
dangcaonguyen OP
206 posts
 
@auxinput,
how about metcal ps-200. There is one used closed to my home selling for 125.
thanks
auxinput
2,920 posts
 

Metcal is supposed to be one of the best stations, but I have never used it.  This particular model is only 35 watts.  The tip determines the temperature, so if you get it, make sure you have a series 600 or 650 tip.  Don't use anything too hot or you're likely to heat and lift the contact pads off the PCB.

My old Weller WTCPT had the same type of mechanism where the type of tip determined the temperature.  It could very well be that I was using a low temp tip (this was many many years ago).  However, I'm totally spoiled with my Hakko - so I may be jaded.  It could very well be that the Metcal or Weller may work out okay.  If it was between the Metcal and Weller, I would probably jump on the Weller because of power output and temp controllability.

Used is not bad, as long as the item was kept in good condition.  I bought a used Hakko 470B desoldering stations years ago and it's still going strong.

auxinput
2,920 posts
 
@dangcaonguyen - thinking about this, I'm pretty sure I had a medium temp tip on the Weller WTCPT.  It still had problems keeping heat on the tip.  Sorry, it's been so long, I can't remember specifics.  Good luck on finding a good soldering station.
dangcaonguyen OP
206 posts
 
Thanks Auxinput.
I did some researches about the Soldering Station and am getting more confuse. Cannot decide of which one I should buy. There are 2 price range. Around $100 and $300. I can afford $100 now. Since i dont do soldering for a living. Will the $100 range station good enough for mu need. I am thinking of the hakko 888 now.
Please give me your best advice.
Calvin
dangcaonguyen OP
206 posts
 
Thanks Auxinput.

More to discover