2. amps-preamps
  3. 126746-12768

How hard it is to replace the rca input on the shindo amplifier?

Hi,
Does anybody know how to replace the rca input in my Shindo Montille Ampplifier?
I bought it used from an AG member. I just discovered that my RCA input was broken. The bass out put from my speakers is distortion. Please give me instruction of how to do it. I already order the Switchcraft RCA jacks which Shindo Used for their amp.
Thanks in advanced.
Calvin
dangcaonguyen
czarivey
5,946 posts
 
Weller WES51 is a correct choice. It's a professional high quality tool sufficiently enough to work with any electronic applications.
For terminating higher gauge wires it's best not to use soldering and use crimping. The maximum power dial for this iron is enough to solder 10awg
biketech60
51 posts
 
Heat flows from the tip to the parts and from the heating element to the tip . You should use the largest spade tip that will work so it's mass , therefore heat it contains is greatest  at any given temperature . Avoid conical tips for most jobs .
czarivey
5,946 posts
 
I grind tip of conical shape to a sole shape and that works very very BEST.
dangcaonguyen OP
207 posts
 
Hello AG members.
I am happy to report back that I have just finished replacing the RCA input jacks BY MYSELF. It took about 30 minutes.
Thanks all of you. Now the bass distortions are all gone.
My system never sounds this good. So clean and clear. 
Thanks.
Calvin

auxinput
2,921 posts
 
Awsome!  Did you end up buying that WES51?
More to discover