bent cantilever

bradf, it is off center where in protrudes. Sorry I was not more specific. 

Please read the above referenced post by Johnathan Carr. He explains that an accumulation of magnetic particles in the area of the magnets and coil can displace the cantilever alignment. He states that the Lyra cartridge can be cleaned internally (professionally) to remedy the fault.
I haven't researched how applicable this would be to your cartridge, but think it would be worthwhile for you to look into, especially if you have no recollection of contacting your cartridge in a manner to cause a bend / misalignment. Good Luck

It may be a non-issue, if it's not too far off being centered. When you align your cartridge, make it so the cantilever is straight, not the cartridge body. There may be no difference in how it sounds, as long as it's aligned properly.

Best of luck, regards,
Dan

Throw it away.Your records are worth more than the price of a new cartridge, and as far as I'm concerned bent cantilever means increased risk of record damage from mistracking.

We'll throwing it away may be going a little overboard.  But it's a pity how many brand new cartridges seem to be coming through with bent cantilevers.  I recently had a bad experience with a very well known manufacturer.  I never should have accepted the cartridge from the dealer, but i did.  Now over $1,000 later after sending it back for a rebuild, i've learned my leason LOL.