I have a coincident phono amplifier and biamped coincident speakers with dedicated 20 A circuits from a separate panel share a common star ground (independent from rest of house).It isn't clear what you mean by " course EMF like noise ." But the problem could be your ground, which you state is not shared with the rest of your house. In the US, this would be a violation of the NEC and is potentially hazardous. In any event, if it's an unshared ground ... to what is your system grounded? It sounds like it's not bonded to the neutral in your service panel, which would tie it back to the electric utility ground. That's your best ground, which of course is supplemented with ground rods as required by code.
There is not ground hum, but when phono to amplifier interconnects connected to amplifiers a course EMF like noise occurs.
Phono interconnects acting as antenna, adding noise to system
Have interesting problem with cable related noise. I have a coincident phono amplifier and biamped coincident speakers with dedicated 20 A circuits from a separate panel share a common star ground (independent from rest of house).
There is not ground hum, but when phono to amplifier interconnects connected to amplifiers a course EMF like noise occurs. The cables seem to be acting as antennas since the noise does not change if disconnected from phono amp but stops if disconnected from power amplifier.
Interestingly, the interconnects are 12feet long running in galvanized conduits under floor to the phono amplifier
The noise is louder if i run in air outside of the conduits. When in conduits only 3 feet at either end is exposed.
does anyone have any suggestions? read that there are braided copper sleeves could try with exposed part? use tinned copper tape? or is there something else going on?
There is not ground hum, but when phono to amplifier interconnects connected to amplifiers a course EMF like noise occurs. The cables seem to be acting as antennas since the noise does not change if disconnected from phono amp but stops if disconnected from power amplifier.
Interestingly, the interconnects are 12feet long running in galvanized conduits under floor to the phono amplifier
The noise is louder if i run in air outside of the conduits. When in conduits only 3 feet at either end is exposed.
does anyone have any suggestions? read that there are braided copper sleeves could try with exposed part? use tinned copper tape? or is there something else going on?
- ...
- 17 posts total
- 17 posts total