Mitch: This is what I understand to make XLR cables;
Pin 1: Ground/Shield
Pin 2: Positive
Pin 3: Negative
I think this is how I made Belden IC's.
Are you saying that just connect Pin 2, put the shield on and connect only at source to Pin 1, and then wrap another 16 gauge Duelund on the shield and connect to Pin 3 on both ends? Just want to make sure I understand, not an expert on this. Just ordered Furutech 601, and 602, and wire from PartsConnexion, they have 25
Pin 1: Ground/Shield
Pin 2: Positive
Pin 3: Negative
I think this is how I made Belden IC's.
Are you saying that just connect Pin 2, put the shield on and connect only at source to Pin 1, and then wrap another 16 gauge Duelund on the shield and connect to Pin 3 on both ends? Just want to make sure I understand, not an expert on this. Just ordered Furutech 601, and 602, and wire from PartsConnexion, they have 25