Rega Owners - Alignment Tool / Protractor


Recommendations for Rega RB700 arm alignment/overhang adjustment protractor; Baerwald? Loefgren?, Rega?
other?

Protractor recommendations; Wallytractor, GeoDisc, Avid, Mint Best, Turn Table Basics, Rega supplied paper, other?

I have read elsewhere on this forum that due to the pivot point placement and length of the arm, the baerewald geometry is not useful on Rega tables.  If you have found this not to be the case, please add a note to this tread stating so.

Thank You
Brad
bradf

Brad, I have a Rega-specific Wallytractor I no longer need (sold my RB300). I believe Wally has health issues, and is no longer producing his products. It was quite an ordeal getting my protractor from him after sending him the $. I had to get Fremer involved, which is what finally did the trick.

The protractor is in storage in S. California, but I'll be bringing it to my new place up here in the Northwest next month. If you're interested in it, you can contact me via a pm if you wish---Eric.

@bradf 
I purchased mine from Analogue Seduction based in the UK. I also ordered the white belts as the P7 needs 2 of them. 

The Avid does not state what geometry they use specific to the Rega, however there are two printed sets of null points and my quick measurements would indicate it is a Stevenson. 
shanticat
Thnx for taking the time to respond, take measurements, and informative response.
I will take a look at Analogue Seduction
Brad
@ bdp24
Hi Eric, I will pm you after the Thanks Giving Holiday Week-end with regards to your Walllytractor.
Sorry I had not answered you earlier, It was an oversight.
I am not sure where in The NW, you moved to; I am in Portland.
Hope your enjoying your Thanks Giving
Brad

Small world Brad! I'm in N. Vancouver (Salmon Creek area), Washington. I'll be heading down to L.A. in a couple of weeks, bringing a trailer full of hi-fi back with me, including the Wallytractor.