2. amps-preamps
  3. 127547-91515

Which pre should I choose?

I have an Accuphase A47 to drive my Dynaudio Coutour 1.3SE. I want to choose a pre-amp to match my power amp. and the speaker system. I prefer classical music. My room is not big. But I like warm and sound with thickness. Do you have good suggestion? How about Ayre's K1XE or Audio Research R2 MKII?
128x128faust168
faust168's avatar
faust168 OP
74 posts
 
Tks for your response, but Ayre K1XE is not easy to find one here in Taipei, there is one in 2nd hand K1  (not K1XE)  store which offer at US$3300. I do not know what is the difference between these two models.  I think it might be the best solution to use a 2nd hand high grade 2nd hand Accuphase pre like C-2800, but it is very hard to find one. Although the brand new C-2420 is more accessible in price, but there is few review on the sound of it's performance.
dlcockrum's avatar
dlcockrum
2,190 posts
 
"...but Ayre K1XE is not easy to find one here in Taipei, there is one in 2nd hand K1 (not K1XE)  store which offer at US$3300. I do not know what is the difference between these two models."

Hi faust,

The K-1 was the first model and can be upgraded to the K-1xe by Ayre for a relatively modest cost. Agree with George that it is a superb preamp and a bargain at those prices.

Best to you faust,
Dave

faust168's avatar
faust168 OP
74 posts
 

The commodity is in Taipei, Taiwan. It is far away from U.S.A. The commercial flight would take 13 hours from here to the states and you have to take transportation to and fro cost into consideration which will push up cost too.   I have read a report that the volume knob in the K1 or K1-XE ( I don't remember clearly about the model), might cause some small noise if the user do not turn the volume up and down often. 

Also, K-1 is a quite old model. I am afraid the components inside might get too old to change it's original tastes.

Therefore, how do you think it is still a bargain to get a K-1 without upgrade?

ryder
1,689 posts
 
You could mix and match with different preamp and power amp though it's a question of personal preference. Personally I would rather stick with the same manufacturer for both pre and power for synergy and/or compliance with technical specification.
faust168's avatar
faust168 OP
74 posts
 

Thank you for your kind opinion. For the purpose of budget consideration, do you think it is good idea to have an Accuphase C-290 (almost 20 years after launch) with my latest launched A-47.

 

More to discover