2. tech-talk
  3. 127625-78931

Dielectric grease on connection ends

I was changing a coil on one of my bikes earlier, and as always, applied a light film of dielectric grease on the coil outputs, and on the spark plug boots. A thought occurred to me that this may be a valid application in audio connections as well. A small amount applied with a cotton swab to bananas/spades/rca's etc. may help, and I'm thinking about giving it a go. Was wondering if this has been tried by any other members, and thoughts on the pro/con aspects.
128x128crazyeddy
atmasphere's avatar
atmasphere
11,837 posts
 
I would avoid it!

The grease is used in high voltage connections to prevent arcing, especially in the case of exposure to water, gas and oil.
Post removed 
crazyeddy's avatar
crazyeddy OP
381 posts
 

@atmasphere 

Yes, that is absolutely correct, which is why it is a procedure I follow diligently, but I can only think there would be no negative aspects in our low voltage audio gear. I have noticed that periodic removal/replacing audio connections has a positive effect. Oxidization/micro arcing/ whatever, I don't know why, I'm not an EE. So, why not apply a light film. Aside from over application and leaving a mess, what could it harm. Just asking.

So why would you avoid it? I'm not being argumentative atmosphere, but would like to know what your thoughts are on any negatives.

More to discover