High Current Outlet for Amps?

hifiman5

@cleeds I guess the electrician who willingly installed that line in that outlet was violating code?  The building inspector too?  Hmmm

Codes vary by location; the NEC establishes only the minimum guidelines. If your inspector approved the install and you're comfortable with that, that's fine. If you don't see the possible hazard of putting a device rated at only 20A on a line capable of delivering 30A through it, then there's nothing further I can add. It's surely a risk I wouldn't and didn't take. Instead, I built several 30A lines, but used a 20A breaker on each. That's a common and perfectly acceptable practice.

 

I do not think the electrician will risk his license to install something violated the code just because I look handsome :DDDDD

gr8av4life

I do not think the electrician will risk his license to install something violated the code

Don't be silly. Electricians don't risk their license for failing to meet code. They simply fail the inspection.

I have two Krell 600 class "A" bias monoblocks, each plugged into a higher quality medical 20 amp outlets.  The cost for the high current outlet is about $20 at any Lowes.  I have seen $200 audiophile outlets advertised, but...that's another can of worms. Each independent line is connected to the same "side" of the breaker box.  This is important, as to assure no added phase problems.  I have all my other equipment going in to the same "side" of the buss, but use conventional outlets, as they are low amp draw components.  If you want to use #10 wire, it's your money and the cost vs #12 is negligible, but #12 should be sufficient, unless the wire run is extremely long.  As wire length gets longer, wire size may need to increase.  A 20 amp breaker will more than suffice and I believe is the largest breaker available, for a conventional single circuit "wall" outlet.  Be sure to always use the screw terminals on the outlet and make sure they're tight.  High amp draw, on a semi loose connection, can cause the outlet, wire and plug to degrade, as well as diminish your sound.  As far as protection of your equipment, whenever a bad storm comes, I physically unplug all my equipment, if I'm home and keep most of it turned off the rest of the time, to protect against possible high current surges.  Having said that, "almost" nothing can protect you from a close lightening strike, if your equipment is "plugged in."  I learned this the hard way.

I have 5 Hubbell HBL5362W in my listening room each on their own breaker with 12 gauge romex.
These on Amazon are the real deal.

https://www.amazon.com/gp/product/B000LE6N56/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1

Careful, there are cheapo versions of these floating around eBay for half the price and the quality is poor. They use this picture but send you something else. If they don't come in their own individual box, send them back. I found out the hard way.