In the meantime if you could post your initial findings on stock out of the box thoughts. They would be appreciated.OK- We took the machine apart doing a complete analysis. I’m very familiar with the older machines; I own one and have serviced them over the years.
The GAE is a ground-up new design, one that is intended to look like a 1200. I think that is unfortunate as it leaves people wondering what Technics was thinking. But that aside:
The machine uses four methods of vibration damping control in the plinth. The platter is more massive and is also damped. The motor has more torque (up to speed in about 1/8 turn) and the speed is rock steady. Speed wise it sits about 80-90% of the way to the top between the SP-10 MkII and SP-10 MkIII. That makes it one of the most speed stable turntables in the world, quite unlike the original 1200s.
The arm is nothing special but is easily removed. With a Triplanar installed this is a world-class machine that takes on much more expensive machines with ease. Technics has a lot of servo experience; in this case they applied it to an entirely new design that is computer based rather than an analog chip set. To that end the firmware appears to be updatable via a USB connection.
Initially we were looking at lifting the motor and circuitry out of the chassis and installing it in a new plinth. However upon opening up the machine it was obvious that Technics was aware the vibration damping is a serious issue. As a result while I think our initial plan would be better, its well past the point of diminishing return! This is an excellent machine and has a place in the high end pantheon of turntables.
I’m not a fan of the arm, but I’ve seen worse and it would be no worries to set it up for balanced operation.