Synergistic Red Fuse ...


I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
Hi George,

The point to the Q&A in my previous post is that we don’t even know if an SR Black 5 amp fuse should truly be considered to be a 5 amp fuse, as opposed to a 4 amp fuse or something even lower. And the reports we’ve seen from a number of people of blown SR fuses would seem to suggest that one of the latter possibilities could very well be the case, for many if not most or all ratings. Also, fuse derating (the margin between the current rating a designer has chosen for a fuse and the amount of current it conducts under normal conditions) is not a precise science, with designer preferences, the limited number of choices that are imposed by standard rating values, and turn-on inrush currents and other characteristics of the particular design all factoring into it.

So my basic intention is to provide food for thought, rather than advocacy. Although per my various posts on the subject I would not consider it to be an unreasonable course of action for someone who wants to try SR fuses to choose values that are one or even two increments higher than stock, and in the end perhaps avoid wasting several hundred dollars as a result. I respect the fact that your opinion differs, and as I said earlier, given the lack of meaningful technical data on the SR fuses I don’t think anyone can provide an answer to this question with certainty.

Regards,
-- Al

So my basic intention is to provide food for thought, rather than advocacy
So your not advocating, increasing the fuse amperage from the manufacturers specified value/s.

This is good Al, for the sake of safety.
As most here don't know if they're changing an ac mains fuse, dc rail fuse or speaker protection fuse. Maybe we've saved a future life, or at least a piece of equipment.

Cheers George 
almarg: "So my basic intention is to provide food for thought, rather than advocacy. Although per my various posts on the subject I would not consider it to be an unreasonable course of action for someone who wants to try SR fuses to choose values that are one or even two increments higher than stock, and in the end perhaps avoid wasting several hundred dollars as a result."

Reads quite differently when not taken out of context, eh, Mighty Mouse?

Ain’t it a pisser when real technical experts like Al refuse to take your bait?

Dave

Bait for the sake of safety? I hardly think so. As I said.
 
" As most here don't know if they're changing an ac mains fuse, dc rail fuse or speaker protection fuse. Maybe we've saved a future life, or at least a piece of equipment."

No one, unless they know what their doing with proper monitoring equipment, should up the amperage rating on a fuse.

Cheers George
Question for Wolf_Garcia ...

Doesn't a fuse prove its reliability when it blows? I mean, what are we relying upon when we put a fuse into a piece of electronics? Surely not that it will never blow no matter what.