Graphene spray and ...

Huh? No more difficult than, say, making titanium tweeters or applying a one molecule thick 24 carat Gold reflective layer on Gold CDs. 

The problem with graphene is it's basically a 2-dimensional substance, and that's not the most stable state for a substance to be in - it will tend to "curl up" into the more stable 3-dimensional state, unless special methods are used, like stated in the Wikipedia article.

Sort of related, B&W put a coat of diamond on some of their tweeters, I'm guessing using chemical vapor deposition.

Since the Graphene is used as a coating it can be applied as a thin light tape, which would be stable. You can buy Graphene tape all over the Internet, no big deal. Even better DIY.

Graphene in by itself is highly limited but when combined with others, its enhancements become notable. In the case of the carbon fiber for the driver, its more likely to be added to the resin solution used in the forming cone and fills in gaps in which remaining resin would typically remain. My expectation is the stiffer cone aided in pushing the cone breakup a bit further out.

The issue that remains crucial with graphene is methods of its application. A few years of experimentation were required to optimize the application of graphene to improve rubber products such as tires and shoe soles. In rubber tires, it resulted in improved strength in the rubber without reducing other performance areas like compound grip. In some respects, it improved grip performance as the lattice aided in maintaining is structural shape of the tread pattern under load. This is often called tread squirm. 

BAC's wheels used on their Mono race car and some experimental bike frames achieved a 20% reduction in overall mass without loss of overall modulus of the finished product. You might even see its application in cabinets construction that use composite materials at some point.

This in addition to the broadened use of pitch based carbon fiber still leaves some development to take place in material science.  

Mmeysarosh I followed up on your comments and found it very interesting
how the graphene helps tire performance in a number of ways. It could find interesting application in ultra high power dragsters where sidewall wrinkling wastes power. I think it will ultimately 
be useful in a number areas in audio,particularly in cones and domes,perhaps competing with diamond, and also maybe even in providing more precision in the rubber surrounds.and as an extreme performance surround material.